|
Post by jake2013 on Jul 16, 2013 21:44:06 GMT -6
Rear wheel took a hard hit and may have slightly bent the axle. Who has swapped theirs and has recommendations on brands, install, etc?
|
|
|
Post by THEYELLOWONE on Jul 17, 2013 5:14:49 GMT -6
Duran has swapped his twice. I've read good things about Ten Factory, better warranty and lower price than many others.
|
|
|
Post by jake2013 on Jul 17, 2013 9:22:53 GMT -6
Duran has swapped his twice. I've read good things about Ten Factory, better warranty and lower price than many others. Yeah I think I read somewhere Duran replaced his bent Nitros with RCV. I would need a loan for RCV, but Northridge has Ten, Alloy USA, and Nitro with the bearings already pressed.
|
|
duran
Junior Member
Posts: 69
|
Post by duran on Jul 17, 2013 13:04:03 GMT -6
yeah i did the swap a couple weeks ago. Swap isn't hard at all. Couldnt tell what brand to go with i've run ten factory( old jeep), nitro's, and now RCVs. Need any help let me know
|
|
|
Post by 1badjk on Jul 17, 2013 19:55:40 GMT -6
I am running G2 axles, had mine installed on the coast.
|
|
|
Post by jake2013 on Jul 17, 2013 20:39:30 GMT -6
yeah i did the swap a couple weeks ago. Swap isn't hard at all. Couldnt tell what brand to go with i've run ten factory( old jeep), nitro's, and now RCVs. Need any help let me know I looked at few write-ups about swapping them and it didn't seem too difficult. About how long did it take you?
|
|
duran
Junior Member
Posts: 69
|
Post by duran on Jul 18, 2013 5:59:16 GMT -6
Takes less than an hour to do both sides.
|
|